![](/static/253f0d9b/assets/icons/icon-96x96.png)
![](https://lemmy.ml/pictrs/image/q98XK4sKtw.png)
I tried Resolve bit came back to kdenlive. It’s just fit my needs much better
I tried Resolve bit came back to kdenlive. It’s just fit my needs much better
The beauty of open source software
I’d say all of the above. Its integration with Kipper is also very good
Which is a fork of Slic3r
And it’s fantastic!
Edit: its actually a fork of bamboo slicer which is a fork of prusa slicer
I used to slicer hop around, then i discovered orca. Just the best imho
Edit: its an open source fork of bamboo slicer
It does, two buttons along the side of the stylus and one on the top end
I have the dell active pen on my xps 2 in 1, it works.
“Couldn’t care less”
Your use case is similar to mine, tailscale works great. Used to have a dedicated VPN but chose tailscale over that.
Not true. https://tailscale.com/kb/1019/subnets
You do not need to install it on all your devices. See https://tailscale.com/kb/1019/subnets
That wasn’t OP’s question though.
This is going to be unpopular, and I will accept the down votes. Also, I will never support Trump or any of his lackies. However, those on this forum believe that she is writing that as “finish them” towards the Palestinians, when in actuality I bet she’s writing that as “finish them” towards hamas. That doesn’t excuse anything. Just stating that they believe they are killing terrorists. They are just ignoring the innocent. Good intentions don’t justify this though let me make that very clear.
Absolutely, you’d be dumb to not use the tools at your disposal
I agree with that. Krita is more of a creation software in my opinion. Painting, drawing, etc.
Tried for days to get a windows 11 guest to work on KVM with virt manager. Couldn’t get very good performance at all. Virtual box with guest drivers is pretty close to bare metal for me. I’d love to use KVM but can’t get good performance
I think it’s all about use case. I’m not 100% sure but the way I use GIMP probably wouldn’t work in Krita. I use GIMP mainly for removing backgrounds so they are transparent, as well as converting raster images to paths so I can make dxf’s of them. This is very easy and fast in GIMP. I think it all just depends on use case.
I’ve been using this for a few days now. The only thing that might make me return to GBoard is the offline voice to text GBoard has. Is that possible to implement in the future?
I went the Solid works hobbyist route, quite frankly, it’s well worth it. I tried freecad for awhile but it just didn’t compare.