Hi there!
I need some help with my framework laptop and fedora. I want to switch to linux more permanently, but fedora does not enter hibernation properly when closing the lid. I dont care 10-20sec of wakeup time when opening it again. (even windows is more efficient?!) The relatively bad performance on battery life is OK for me, I already installed TLP instead of the default power management. But when closing the lid, the battery drains about 80% over night (10h?) which seems to be more than what other people reported.
I could not find a guide on this, which i understood (still a massive noob to afraid to mess up my carefully crafted linux partition :D).
If you have any advice I appreciate it! Thanks a lot! :)
In first you need understand what type of suspend you use:
Suspend to RAM (aka suspend, aka sleep) The S3 sleeping state as defined by ACPI. Works by cutting off power to most parts of the machine aside from the RAM, which is required to restore the machine’s state. Because of the large power savings, it is advisable for laptops to automatically enter this mode when the computer is running on batteries and the lid is closed (or the user is inactive for some time). Suspend to disk (aka hibernate) The S4 sleeping state as defined by ACPI. Saves the machine’s state into swap space and completely powers off the machine. When the machine is powered on, the state is restored. Until then, there is zero power consumption. Hybrid suspend (aka hybrid sleep) A hybrid of suspending and hibernating, sometimes called suspend to both. Saves the machine’s state into swap space, but does not power off the machine. Instead, it invokes the default suspend. Therefore, if the battery is not depleted, the system can resume instantly. If the battery is depleted, the system can be resumed from disk, which is much slower than resuming from RAM, but the machine’s state has not been lost.
I think you use Hybrid suspend. Hybrid suspend store memory to disk (20 seconds lag) and then lost battery for memory renew. Need you Suspend to RAM maybe? 20 Seconds lag will fixed with that.
Then check
cat /sys/power/mem_sleepIf you see
[s2idle] shallow deepcheck first if your UEFI advertises some settings for it, generally under Power or Sleep state or similar wording, with options named Windows 10, Windows and Linux or S3/Modern standby support for S0ix, and Legacy, Linux, Linux S3 or S3 enabled for S3 sleep.
If you don’t see anything you can swap sleep mode to Suspend to disk. That slow but don’t use any power. Or try fix sleep status.
More information you can find here: https://wiki.archlinux.org/title/Power_management/Suspend_and_hibernate
Thank you for your reply. It says:
[s2idle] deepI don’t think i have the swap partition, I will try to create that. Thanks!