I installed it from the Calamaries Installer found in the LIVE USB ISO this time. And Instead of my primary hdd, I installed it on the other one. Works now, thanks for all of your support, dear nerds.

    • rotopenguin@infosec.pubEnglish
      5·
      4 months ago

      Considering that it has a 2020 firmware, and is built by “to be filled by OEM”, my completely unfounded wild guess is that the system firmware has broken legacy boot support. From other posts here, I gather you’re using a legacy dos-style partition table. Try installing again with GPT/EFI instead.

    • arandomthought@sh.itjust.works
      1·
      4 months ago

      Absolutely not an expert or anything, but is it possible that the partition of your harddrive that you’re trying to install Debian on (hd0) is too small?

        • Corngood@lemmy.ml
          1·
          4 months ago

          The original error actually makes it sound like there’s a partition on hda that’s bigger than hda itself.

          • senilelemon@lemmy.worldOP
            1·
            4 months ago

            Partition size wasn’t specified in any step of the setup. If that is the issue, Is there any way to fix it?

            • bsergay@discuss.online
              1·
              4 months ago

              At some point, the installation should ask you the driver on which it should be installed and also how the driver should be interacted with; i.e full wipe and then installation or only specified partitions. You specified elsewhere that you don’t intend to dual-boot. Hence, selecting the correct drive and following the instructions for full wipe + installation (which should be regular/default installation) should have been sufficient.