I was able to get it printing, but doing some calibration confirms that adjusting z offset made the bottom layer better. What’s the point in z offset specifically, vs just changing the gap when tramming or the initial layer height?
I was able to get it printing, but doing some calibration confirms that adjusting z offset made the bottom layer better. What’s the point in z offset specifically, vs just changing the gap when tramming or the initial layer height?
Increase in temp seemed to help!
This was the brim printing. But increasing temp did seem to help!
This is a really interesting idea! Ill give it a try.
Increasing temp by 5, plus recleaning the bed, plus doing some cold pulls helped a bit. I’ve always had issues getting things to stick at 60 for some reason, at least ever since I went to borosilicate. I’ll try adding more squish, since I have to dehydrate my filament before I give the print another shot.
I’m ashamed to say, I do z offset by just tramming with a feeler gauge to adjust. I believe my initial layer is .2mm and I trammed it to.05mm and it smooshed too much, and still peeled up. .07mm was much to tall, and this was at .06mm. I finally got the print working after doing some more cold pulls and recleaning the glass a little better.
It is borosilicate, which is a decision I’ve come to regret. Using hair spray and glue sticks works, but is so messy to clean
Yeah I was doing that for a bit but I hate cleaning it off the plate. I should have never switched to borosilicate 😂
They over estimated America’s intelligence.
Can they sell it to Michigan, or would that be a problem federally speaking?
I just can’t bring my self to vote for a geriatric Cheeto or a geriatric genocider.
Bernie 2024
Israel has been facilitating payments from Qatar to Hamas to keep them in power in case you didn’t know. They created this situation on purpose. Hamas sucks, but Israel fostered it as an excuse to commit genocide.
And this is something that actually makes sense.
The finals is also only voice chat and its opt in from the get go, so really good for avoiding toxic behavior from randos
Agreed! Came here to mention it. It’s a widget only, and very minimal but I love it. I only wish I remembered to look at it more often.
It’s more about rcs compatibility, which to be fair google was really late to the party bringing it around.
Wasn’t russia also a part of the remake? I vaguely remember that movie and can’t recall much other than a mustang with a m134 or some goofy shit like that.
I care a lot about what happens to them. I hope there is a hell just so they can burn in it.