• 3 Posts
  • 15 Comments
Joined 1 year ago
cake
Cake day: June 13th, 2023

help-circle



  • Thanks for the answer.

    Just checked with lspci -v and it says radeon:

    03:00.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Cape Verde PRO [Radeon HD 7750/8740 / R7 250E] (prog-if 00 [VGA controller])
            Subsystem: PC Partner Limited / Sapphire Technology Cape Verde PRO [Radeon HD 7750/8740 / R7 250E]
            Flags: bus master, fast devsel, latency 0, IRQ 28, NUMA node 0
            Memory at d0000000 (64-bit, prefetchable) [size=256M]
            Memory at fbf80000 (64-bit, non-prefetchable) [size=256K]
            I/O ports at e000 [size=256]
            Expansion ROM at 000c0000 [disabled] [size=128K]
            Capabilities: [48] Vendor Specific Information: Len=08 <?>
            Capabilities: [50] Power Management version 3
            Capabilities: [58] Express Legacy Endpoint, MSI 00
            Capabilities: [a0] MSI: Enable+ Count=1/1 Maskable- 64bit+
            Capabilities: [100] Vendor Specific Information: ID=0001 Rev=1 Len=010 <?>
            Capabilities: [150] Advanced Error Reporting
            Capabilities: [270] Secondary PCI Express
            Kernel driver in use: radeon
            Kernel modules: radeon, amdgpu
    

    Is that the one it’s supposed to be active?

    About the allocate thing, I think that is a number and not an index in an array. I think that you can allocate as many gpus you want:

    I’ve seen that same menu in screenshots and I’m supposed to be able to choose something different from zero.



  • I’m really thinking about starting from scratch. The rabbit hole kind of scares me but at the same time it’s exciting 😂.

    I think I have room to grow in the new home and I always try to get things with local integration and as open source as possible.

    My setup right now is in a small flat, with 3 or 4 automations and a very small amount of sensors. The new home is going to be very very different. I have a lot of plans, maybe too many of them. So maybe staying from scratch is the way to go.

    Thanks for your input









  • Same here, I’ve been using an aqara ZigBee sensor for more than two years and it works great.

    I designed 3d printed rain proof enclosure and it’s been reporting outdoor temperature and humidity for more than two years with no problem.

    The worst part for me is the changing the battery. The sensor is on a hard to reach place and my design is not the best, so I fear when the battery gets low.

    I was planning to build something like this for the rain.