Want to share?

Off the top of my head I have seen units being teleported because tiles are incorrectly linked.

Are you having a stroke?

Make sure the bed isn’t wobbly. This happened to me as well. I had varying results until I fixed that. I’m on my phone at the moment and unfortunately don’t have it. I think you can find it on Cults3D if you search for sprite extruder strain relief.

I have the S1, I will strongly recommend you to print a strain relief for the ribbon cable from the extruder. Mine broke rather quick and creality sent a replacement just from hearing that the extruder stopped working so it’s probably a common issue

Yeah I’ve been printing a little PETG at about 240, but it’s something I rarely do so I haven’t opted for a all metal hotend and as I understood it I thought it was okay until about 250 C, but I guess not. It’s really mostly PLA that I print though.

I’ll look for a PTFE cutter, thanks!

I would recommend a textured bed. I also tried PETG on glass but the adhesion is better on a textured bed. I’ve been able to print at 240/70 on a PEI sheet. I have an Ender 3 S1

This has been ruled out as an accident by Danish authorities. This is a murder investigation now

I love my panniers on the Z1000SX/Ninja 1000, they integrate seamlessly into the rear handles so you can’t tell the bike can carry bags unless they’re on. They can fit a helmet and they look nice. Starter key of course also opens the bags and locks them to the bike.

I had a top box on an older Honda, terrible experience. Taking the bag off the bike meant working with the same mechanism that held the bag shut. One time going to a date of course resulted in opening the bag while taking it off and spilling the contents in front of her.

Is this programming humor?