I’ve watched Nerdtronics videos and they’re gold. Great quality and really, really clear! Thank you again

Really thank you! So Blender + Cura. I will start to learn Blender, thanks!

Thank you very much for all the indications. I will follow everything of what you have said!

Wow! That’s a lot of useful info! I’ll check the Nerdtronics videos and all the models that you’ve shown. Thank you very much!

Ok, thank you very much. These prints will be used only to decore cakes and those cakes are only for photos and not meant to be eaten. So I will check Blender, do you have any suggestion from where to start (any YouTube channel, books, courses or guides)? And then Cura. Thank you again!

I would like to make kid’s cartoon characters (forx example: Bluey, Miracolous, Disney…), about 6-8 cm of height at max so I can put them on the decorative cakes for the photos.

Thank you! I would like to print little cartoon characters for decorative cakes. I can’t find them on the web so I was thinking that I could make them.

Thanks for the suggestion. I’ll look into Tinkercad for starting.

Actually I don’t have any printer and I really don’t know where to start looking at. Thanks again

Thanks for the suggestion :)

Ok, thanks for the clarification. I’ll check Bottles

Thank you, I’ll try it too!

Thanks to everyone for your answers. I’ll check Lutris and Bottles!

I didn’t know this, thanks!

Thanks for the help :)

Thank you very much!