Doesn’t systemd have the ability to do this as well with unix sockets?
I’m a maker.
Doesn’t systemd have the ability to do this as well with unix sockets?
I don’t recommend using the shell on routers for day-to-day management. Instead, consider using a network configuration management system like rconfig. I’ve used RANCID in the past, but I suspect something more modern like rconfig will be useful to you.
Factory battery was probably charged to a normal level and would’ve paired fine when opened if it’d been powered off. It was left powered on from the factory, which is not how it should’ve arrived. My experience is a valid criticism of a just-released rechargeable device and a QA issue. Where do you get off acting like I don’t know how consumer electronics work because I’m criticizing bad QA?
I just got mine too. Nice and klacky. Mine arrived on in 2.4GHz mode, so I had trouble with pairing until I charged it. Works great now though.
I subscribe to !newcommunities@lemmy.world which helps. Other than that I look for mentions of other communities in comments, similar to how I used to on reddit.
I just gave this a play-through because of your recommendation. What an adorable game! Thank you for sharing it.
Before you go through a bunch of calibration, I’d see if it happens with a different filament. Those black particles there are likely something with a higher melting point than the surrounding PLA, otherwise they’d “smear” during printing. I’m betting you’re hitting some intermittent clogs. See if the problem happens with a single color filament.