I see, thanks for explain.
Driveline is no need to lubricate, because it’s belt drive system(at least in Model 7). Parts fit well, bearings, belts etc (although, that depends on how well calibrated is your printer). I think that system is strong enough. I built it with brushless motor and it’s wild.
Only challenging parts were ball joints. I had problems to fit them in place, but I found a way.
There is belt gearbox, I found belts in my local shop. Or how did you mean your questions? I found all in non printed parts bom
It’s called effiency
Very much. Can print bigger projects, or smaller one with more parts on the same plate (for example, rims for rc car, which is technically part of the bigger project)
Nice. Personally, I don’t think that I could find use for that size. I wanted little bigger than 220x220mm because projects
I was thinking about the weight. Anyway, thanks for the info
Is it safe to put dryer with filament on top of the box? I have Tukkari for my Mini and I haven’t try that yet
What phone are you using?
Realme GT Neo 2 5G, Android 13.
Are you happy with it? What are its best and worst qualities?
Yep. It’s silly, but I like green back colour. Decent storage(256gb), enough RAM(12GB), good battery. Maybe little bit better camera. But for that price, I’m happy with it.
Which phones have you had previously? Which were the best and worst of the lot?
Nexus S, HTC One M7, Xiaomi Mi4C, Nexus 5x, TCL Plex. I liked HTC, front face stereo, aluminium body. Worst was Xiaomi. I hated that phone, MIUI was (still is) bad, SoC was bad, battery didn’t last long.
How often do you upgrade to a new phone?
Until there are some defects (battery and display on TCL for example) or destroyed (Xiaomi) or it was simple too weak on performance for me(Nexus 5X)
What other Android ecosystem devices do you have? Watches, headphones/earbuds, etc.
Not clearly only Android devices. Yes. Headphones and watch
Do you also use any Apple products, or are you Android all the way? (And/or Windows, Linux, ChromeOS, etc.)
Windows on laptop. That’s all I use.
I have Sunlu S1 dryer. I added fan and changed thermistor position. I tried it with PLA, PETG, ASA with good experience. S2 have two heater plates, touch display. But for me, it have filament out way in bad position.
It’s recommended to use PC or ASA for motor parts. I used ASA