Thanks for all the suggestions! I switched to qbittorrent and it works nicely for now. The web ui is fine for the little I use it so all good! I’ll report if something starts failing again which would indicate another issue with me setup.
Thanks for all the suggestions! I switched to qbittorrent and it works nicely for now. The web ui is fine for the little I use it so all good! I’ll report if something starts failing again which would indicate another issue with me setup.
Seems to work very nicely and it’s much more responsive than transmission. Great, thanks!
I’m not set on transmission, I tried qbittorrent just now and it seems to work for me. But thanks! I anyway use a separate container and network for vpn.
I’ll give it a go! Is there a GUI for it? I like to sometimes check the progress live and transmission provides that out of the box.
Yeah their security track record as of late is pretty bad…
Something like this is a good start! I use transmission as the torrent client instead of deluge. Also added a service for my vpn and use that as the network for the tranmission service so all traffic is routed through the vpn. https://ochoaprojects.github.io/posts/PlexAutomation/
deleted by creator
Interesting, that would confirm the pressure advance as the likely culprit (speed and acceleration are taken into account in the algo). Maybe your slicer has a bug related to this? If changing the value wildly does not improve or worsen it, then it might not be calculating what it’s supposed to. Can you try another slicer?
All seems to indicate something related to pressure advance, whereby the printer thinks it needs to extrude less because of some pressure buildup but it underestimates how much is really needed. Does it happen if you print slowly? E.g max 15 mm/s or less.
I reported the bug to Proton support and they said they are investigating but suggested I uninstall and reinstall the extension. I did and lo, my forms started working again. I can recommend you try to uninstall and reinstall too (disabling it was not enough).
Note that the “plus” suffix doesn’t hide your real email, that’s a small but notable difference. I could well see websites parsing for +… patterns and removing them before selling your data.
That’s cool! I’ve used enough raspberry pi’s over the years to know that SD cards, even if industrial grade are likely to fail at some point so I try to avoid booting from them. eMMC would be much better but sometimes a pain to flash depending on the tooling available. Having a SATA port would allow to use HDDs which provide a lot of capacity for cheap. I guess the processor needs to be an Amlogic for the best media experience?
How does storage look/work with a SBC? Do you have to boot off of an SD card? Any support for sata drives?
This is mostly a cooling issue. Not being able to solidify the plastic fast enough after it’s been deposited.
Have you seen how fast printers with stepper motors can get? They print benchies in less than 3 minutes. The bottleneck is not the motion system, it’s either the hot-end or the part cooling. Also stepper are super accurate and very flexible. Drivers are advanced and can tune for torque, speed, sound etc. Collision detection and skipped step detection is also a thing.
Sounds like you found a bug, it’s worth submitting to SuperSlicer
Can’t you just create a new account on ygg when you reach your quota? Or ratiomaster
It’s pretty nice. It’s just a very simple front that will add a series or movie to radarr or sonarr. Not great for discovering new stuff but the search works well to find stuff you’re looking for. No complaints from my side!
And install python and install those dependencies before you can even run the thing