DarkwingDuck

Torrenting often maxes out my download speed as well.

Probably keeps it on 100% for extended periods of time.

Maybe slight overextrusion looking at the bow sides. Needs retraction tuning as well, looking at the smokestack.

Bye bye warranty?

I’ve gotten it to float upright with surface tension before using some custom slicing in Cura. But once the inside gets wet, it no longer stays up.

I basically did 100% on the bottom aft, and 8% everywhere else. Still doesn’t float that well.

I had the exact same thing happen to me (previous owner left old wheelbarrow). And what I did was take the wheel off and put a bicycle patch on the hole. Good as new.

That being said I put probably 25+ bicycle tire patches on my life, so it was cake for me.

I have no idea how many followers I have because I use the old interface exclusively.

I’ve been on reddit for a couple years before the flood from Digg. The quality of content and especially comments went down right then, and never recovered.

Personally I skipped Digg entirely.