I think upstate is forecast to be one of the clearer places
I think upstate is forecast to be one of the clearer places
This is one reason I’m switching away from pla+ back to normal pla. The esun pla+ really seems to get brittle when held under stress. This is an issue with printed parts as well. I’ve had parts suddenly crack in half where they were stressed over a few months.
Also it’s really annoying when little bits of filament get stuck in your filament guide tube :(
The symptoms you describe are exactly what happens to my machine when it runs out of memory and then starts swapping really hard. This is easy to check by seeing if disk io also spikes when it happens, and if memory usage is high
I use a pixel 2 XL, but I run lineageos 21, based on android 14. I also had the feature in lineageos 20 based on android 13.
It’s possible this is a lineageos specific feature. A quick google seems to imply that this is likely so. Unfortunate :/
Mine has a setting to not send more than one notification within X minutes I under settings > notifications > app notifications > some app > minimum time between notification sounds
Is the bad side of the seam where it stops or where it starts printing the outer wall? I assume it’s where it stops and then it cross the wall to form the infill?
To add to the PA questions, are you sure that your PA setting actually are changing anything?
What printer is this and what firmware?
Does a spiral mode print work fine?
What if you print the part significantly slower (to rule out rigidity/acceleration issues)
On linux and Mac there’s also https://vorta.borgbase.com/ which is pretty good
Your filter rule association is set to ‘rule’. What is that associated rule, and do things work if you change it to ‘pass’?
https://www.reddit.com/r/opnsense/comments/puty62/correct_option_for_filter_rule_association_when/
Instead of connecting with a web browser, can you try using curl or telnet just to check if you’re getting through at the TCP/IP connection level?
That make sense. I would use tags like that:
Flickr Published
year roundup/2022
type/Landscapes
type/Portraits
events/trips/Zion 2022
content/food
content/animals
I actually do event level as my on-disk sorting. And then tag for stuff that’s not that. But I think it would work pretty well to do the event sorting under tags as well.
Then I rate my favorite photos, usually using the green approved, not stars. But stars would work too. Then if you want to find say, favorite landscapes, the digikam interface makes it really easy to do so.
I’m not sure if you can select what tags get written into the image, but if you can, you might be able to exclude certain parts of the hierarchy, and only include content/
or type/
subhierarchies
One of the things I really like about digikam is the matching of the disk layout with the album structure. This makes it really easy to have other programs also interact with my photo library in a way that’s near impossible if you instead have an internal photo database.
Tags work great for me for multi-categorization. What feels clunky about them in your workflow? You’re even allowed to have a tag hierarchy.
For gaming like that (remote over the network), I’d recommend sunshine and moonlight. They work great if your network can handle the upload
I think you want something like \s*\(((?!ver\s\d).)*\)\s*
See regexr.com/7jbvk
Basically this consumes all characters between parentheticals with whitespace unless the next character set in the parentheticals is ver
followed by a number. Now this uses a negative lookahead which might not be supported by the engine that krename is using. You can also explicitly construct the group to not match, but that’s rather painful, see here
Your ISP knows where you’re going anyway. They don’t need DNS for that. They see all the traffic.