The concept of no-fault divorce must infuriate you.
The concept of no-fault divorce must infuriate you.
Wiretapping laws don’t cover who you can take photos of.
I wasn’t even given an option for sound, the guy told me the headphones were just for communicating. I just tanked 30 minutes in the tube with nothing but the sound of vibrations.
Yeah but this whole post is about resin prints, which cannot be acetone smoothed.
if you turn off end to end encryption
isn’t that the main reason to use it though, privacy?
No, the reason clear 3d prints are cloudy is because layer lines cause scattering, which makes it appear cloudy. Coating the surface with a clear epoxy fills in the tiny gaps that causes light to scatter, improving the optical clarity.
Is the part in the middle not 3D printed? It says Formlabs Form 3.
Than 35? No, you’re not going to build a new printer from scratch for less than $35, especially if you don’t have another printer to print parts.
Buy a hotend, figure out what you did wrong previously, and fix your machine.
No, the magnets are just as dangerous when scans aren’t happening. They are always on.
I’ve certainly never met a perscriptivist who I held in higher regard than Mark Twain.
Dude, that looks rough as hell compared to any resin print. I don’t get why some people just have to cope so hard over this, resin is just better for detail, it’s not a comment on your print skills or whatever.
One slight correction, nothing is stopping you from using Klipper with Octoprint. You just need to install the Octoklipper plug-in to Octoprint. Most people who run Klipper choose to use Mainsail or Fluidd, but it’s not required.
Nah.