Right in the middle of an absolutely massive print this x axis shift occurred. MK4 printer. Printer ran a calibration just prior to print. Once my tears dry up, and I buy some more filament, how do I prevent this from happening again when I retry this?

  • SkyezOpen@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    Had slipping issues for taller prints as well. Brought the print speed way way down and it seemed to work.

    • Imgonnatrythis@sh.itjust.worksOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      It’s a 48h print with variable print speed. I wonder if the variable speed threw it off somehow. I will check my belt tension. Will be a little disappointed if that’s already off since it’s a fairly new printer. Will try the reprint without variable speed and maybe I’ll simplify the design elements a bit.

      • FuglyDuck@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        If belts are tensioned not too tight and not too loose;

        The next thing to look at is the drive gear on the x motor- if it’s a bit loose, it could slip.

        Another thing is the hotnend mount- if it’s Loose it can wiggle back and forth as it drags on the part.

        Then, finally; if none of those seem off; check the x motor itself for voltage and overheating.

      • TwanHE@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Belt tension should be checked regularly and definitely before printing on a new machine. It being new doesn’t have anything to do with belt tension.