https://imgur.com/a/oXQJArS I’m hoping you guys can help me figure this out. I have an ender 3 pro, running on marlin firmware. Every time I try to print something one of the corners will lift up like that and ruin the entire print. I installed a crtouch to help with leveling, installed upgraded metal bed wheels to help it not fall out of level. Even tried a glass bed with glue and it still does the same thing. I used a filament dryer and have a heat enclosure. I’m starting to run out of ideas on how to fix this. Any suggestions? The pic is how it starts and that was just a brim since I used to always use a raft and thought I should try that instead.

  • Silfeed@fedia.ioOP
    link
    fedilink
    arrow-up
    2
    ·
    2 days ago

    The last time I cleaned it I used 99% isopropyl alcohol, hoping to get a good clean on it with no luck. I’ll try using a lower percent next to see if that changes anything

    • thisbenzingring@lemmy.sdf.org
      link
      fedilink
      English
      arrow-up
      1
      ·
      2 days ago

      get a box of the alcohol prep wipes, they wont leave residue and you can one and done them while taking away the almost invisible film that will build up after a few uses

      • Silfeed@fedia.ioOP
        link
        fedilink
        arrow-up
        2
        ·
        2 days ago

        I have a box already but never thought of trying those out. Thanks for the tip!