https://imgur.com/a/oXQJArS I’m hoping you guys can help me figure this out. I have an ender 3 pro, running on marlin firmware. Every time I try to print something one of the corners will lift up like that and ruin the entire print. I installed a crtouch to help with leveling, installed upgraded metal bed wheels to help it not fall out of level. Even tried a glass bed with glue and it still does the same thing. I used a filament dryer and have a heat enclosure. I’m starting to run out of ideas on how to fix this. Any suggestions? The pic is how it starts and that was just a brim since I used to always use a raft and thought I should try that instead.

  • Silfeed@fedia.ioOP
    2·
    2 days ago

    I’m working on it right now to try out some of the suggestions people have given me. I’m waiting on a thermometer to come in so I can make sure my printer is giving accurate temps. I’ve had similar issues with the glass as I am with the magnetic, but if I can’t get my current test to work I might try again on glass. Right now I figured out how to get mouse ears on the corners so I’m giving that a shot. I have cleaned it a few times already but maybe I used too high of a percent on the ipa so I’ll try again with a lower percent.