This came from my Bambu P1S, I did a hotend replacement a week ago and I only print simples models since. This time I tried to print a model a bit more complexe with supports and it failed. Filament is dry, ambiant humidity is 7% in the AMS.

Do you have any suggestions ? Thanks

  • paf@jlai.lu
    link
    fedilink
    English
    arrow-up
    2
    ·
    3 days ago

    Did you check preview mode on slicer? Do you use your own settings? Is purge line always that long?

    • gdaofb27584@lemmy.mlOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      3 days ago

      I use factory preset “0.2mm standard” for a 0.4mm hotend. The purge line looks normal to me. I had an other comment with bambustudio and freecad files.

      • paf@jlai.lu
        link
        fedilink
        English
        arrow-up
        1
        ·
        3 days ago

        Looking again at your pic and wonder if part tilted while printing due to small area on bed. If it did, adding manual support to the print would help to stabilise as it goes up. Only thing is, that doesn’t explain why there is filament on the right of the picture.