This came from my Bambu P1S, I did a hotend replacement a week ago and I only print simples models since. This time I tried to print a model a bit more complexe with supports and it failed. Filament is dry, ambiant humidity is 7% in the AMS.
Do you have any suggestions ? Thanks
Check your bed adhesion (clean the bed with detergent and hot water, and I recommend a quick wipe with 91% IPA before each print) to prevent the model rotation seen in this picture, but in general parts with that little bed contact can be difficult to print correctly. If you can’t find an orientation that fits on the bed with more surface area, then slow the print down to minimize forces pushing the print. While supports help, they don’t hold onto the print as firmly as the bed does (on purpose).
I’ve run into some frustrating issues with small contact points with print beds. Another option is to use a smooth PEI plate and use a glue stick or Bed Weld or something to help improve adhesion.