Bambu Labs make indisputably excellent printers. However, that excellence comes at the cost of freedom. After a firmware release earlier this year, Bambu printers could only work with Bambu’s…
It’s the kind of enshittification Bambu is moving towards. I kind of expect them to do something like this in the near future, only allowing the “correct” filament and hiding the full potential of “your” machine behind subscriptions nust like car manufacturers.
Honestly, I don’t see it happening. Granted, I’d be spared that outcome anyway, I run custom firmware on my X1. But while they’re a bit of a pain about some things, I don’t see them taking steps like that. They’re more of a Chinese pain (don’t share the source code, don’t follow the standards) than an American pain (money at every turn, subscriptions, vendor lockouts, etc).
It’s the kind of enshittification Bambu is moving towards. I kind of expect them to do something like this in the near future, only allowing the “correct” filament and hiding the full potential of “your” machine behind subscriptions nust like car manufacturers.
And when if they happens sure shit on them but people are like this is what is going to happen.
Honestly, I don’t see it happening. Granted, I’d be spared that outcome anyway, I run custom firmware on my X1. But while they’re a bit of a pain about some things, I don’t see them taking steps like that. They’re more of a Chinese pain (don’t share the source code, don’t follow the standards) than an American pain (money at every turn, subscriptions, vendor lockouts, etc).