I’m having a rather strange problem with my Ender 3 V2 that’s causing me to leave it unplugged and as a result underused.
I used to have my printer set up in my garage but one day noticed that the circuit breaker was tripping overnight resulting my refridgerator to turn off (not ideal.) I kept removing devices until I determined that it was caused by my 3d printer despite the PSU being completely flipped off at the back! This is obviously strange behavior and not ideal for a device that is outside of it’s warranty period.
So I’m not sure how to proceed here. Firstly, what type of issue would cause this device to trigger a circuit breaker even when the PSU is turned off? Secondly, is there some way to fix this device that isn’t a major PITA? Has anyone else experienced this as well?
Is the PSU in V2 any less shady than in old Enders? The almost naked industrial unit was easy to install with wrong screws that reach into the circuit board or have things fall into the contacts or through the slots inside.
I’d look at the cable and the switch and any connectors and connections there first.