I have a Nevermore filter with 24v fans, would it be fine to connect them to the parts that I have circled on my Prusa MK4?

Or is that dangerous?

  • FuglyDuck@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    Volts need to match, nominally.

    Your fans will only draw .1A from the supply- as long as your supply has enough amperage to supply everything running… your fine.

      • FuglyDuck@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        19 is probably fine. Voltage is always a bit inconsistent so the phrase they use is “nominal”- or “more or less”

      • CmdrShepard@lemmy.one
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        With a fan it won’t be a big deal if the charger outputs 19-24V. Do you have a multimeter? Do you have a 24V source anywhere on the board? Using a laptop charger for 24V/0.1A is just way overkill. It’ll work just fine though. You might also get some 24V LEDs to run off it too since you’ll have all that extra current capacity.