I ran a selftest and the manual test and the X-axis keeps failing. I don’t know why.
I tried:
Re-lubing
adjusting the X-axis belt
Adjusting the cables
I’ve had no luck with anything :/
Edit: I’ve watched a video and the extruder just hangs on the left side it for most the time it doesn’t go left then right, right aaway
Edit 2: I found the issue that I completely overlooked cuz I was annoyed…the bearing was sticking out somehow
Prusa machines come with phenomenal support, why not consult them directly?
Figured I’d make a post while I wait the 30 minutes
Was it a kit? Had it been printing before you started getting this issue or was this an issue out of the box?
Yep.
deleted by creator
Yup. And not sure if it matters either but x axis reads as 251
deleted by creator
I’m dumb, I found the issue…One of the bearings was sticking out Idk how I missed that especially looking stuff up ;-;
deleted by creator
Np lol. I honestly didn’t expect it, like it’s screwed down so how could it move? I love troubleshooting soooooo much