Any ideas as to what I’m doing wrong?

This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge.

I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

  • JoShmoe@programming.devEnglish
    31·
    10 months ago

    That ridge looks like it’s part of the model. Can you confirm its not supposed to be there?

    • Tarnaq@lemmy.worldOPEnglish
      2·
      10 months ago

      It’s not supposed to be there, there was no ridge when I was supporting and slicing.

      • GrindingGears@lemmy.caEnglish
        2·
        10 months ago

        If it’s in the same spot every time, it’s very likely something wrong with the model. It’s inexplicable when this happens, but it does sometimes. Could try a different sd card, doubt that will make a difference, but you never know.

        To me, it looks too uniform and consistent to be something with the printer.