Just finished building this beast. It’s a ratrig Vcore 3.1 with a 500x500x500mm build volume and blazing speed.

  • heschlieA
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    North of ~25mm^3 I’ve found I need to really up the temps to keep up with PLA (mainly using eSun) which then also means a lot more cooling. I managed a pretty decent 14 minute benchy but need to retest as I’ve upgraded my cooling.

    My current setup for extrusion:

    • Rapido high flow with CHT
    • Orbiter 2 with blowy mod to run at higher current
    • CPAP remote cooling with a WS7040 blower
    • HUVUD toolboard on printhead
    • GoldenSpamfish@lemmy.zipOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Mine is basically the ratrig recommended defaults except for the CHT, a beacon scanner, and a carbon fiber rail. I got to a 16 minute benchy basically immediately, but anything else I print that fast causes either skipped steps or belt slips and I’m not sure why.

      • heschlieA
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Nice not bad! A pretty easy upgrade for power (if you have a mainboard that supports it) is to go to 48v for the steppers with 5160 step sticks, gobs more power, but you are also now getting to territory where a crash can start really breaking stuff. There is also a group in the discord where they are working on the AWD mod to add 2 more steppers to the XY motion allowing for insane speeds.