https://imgchest.com/p/na7klqbby8d

So along the two sides that aren’t sticking properly, they were kind of bridged on there which explains the issues, however my second attempt printing with supports resulted in the same issues. I’m wondering why that is. I’m going to start printing with the fans off to see if that is the issue, everything else looks fine though. Let me know if you guys have any advice for better quality prints.

  • CmdrShepard@lemmy.one
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    A brim will help but the biggest thing is not to use fans at all during the first several layers and very sparingly after that. Also be sure your printer isn’t getting hit by a draft from an air vent or open window. PETG warps badly like this from too much cooling/temperature variation.

      • CmdrShepard@lemmy.one
        link
        fedilink
        English
        arrow-up
        4
        ·
        1 year ago

        Try with maybe 20-30% speeds after its printed several layers at 0%. You might even try your idea of zero fan the entire time. It’ll take trial and error so you may figure out a way to test on a smaller print so you don’t waste a bunch of filament.

        • /home/pineapplelover@lemm.eeOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          I’m starting out with 0% first. However, I wonder if it will break my hardware as a device melting plastic at 245 C should have some cooling system or it will burn up right?

          • hibbfd@kbin.social
            link
            fedilink
            arrow-up
            2
            ·
            1 year ago

            typically the fan cooling the heatbreak and extruder stays on even with the “extruder” aka part cooler fan turned off

          • CmdrShepard@lemmy.one
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            As the other person stated, the hotend has two fans. One for part cooling and one to cool the extruder itself. The latter is usually controlled by the printer with no way for you to change it (apart from maybe rebuilding your own firmware) so you will be good to go running at 0%. The issue with this is that some part designs need the plastic to be cooled quickly for things like bridging, which is where you’ll run into issues having the part cooling fan turned off. That probably won’t be an issue when printing a box though.